YH-SXD-005（ LED fountain lamp）
- 01： Product specification：Diameter 150MM/160MM/180MM/200MM
- 02： Product power：6W/9W/12W/18W/18W/24W/36W
- 03： Product voltage：DC12V /DC24V
- 04： Light source: High power LED （OSRAM, CREE, Epistar, Bridgelux, San'an, etc. ）
- 05： Light source color temperature：2200-6500K RGB RGBW
- 06： Irritation angle：10-90 degree
- 07： Light Source Life：50000H
- 08： Protection grade: IP68
►Precautions before installation
Unpack and carefully inspect the product, please take it lightly;
If any damage is found in the product, please keep the product packaging and report it to the customer in time;
Please do not try to use a damaged product;
The installation of the product must be a licensed professional electrician;
Non-professionals are advised not to dismantle or repair, and our company has the right to refuse to replace or repair the products that have been dismantled or repaired.
Please disconnect the power before installation, and it is strictly forbidden to operate during the installation process;
Open two holes of the same size as the screw holes on the physical product bracket at the place where they need to be installed, and install the screws;
Adjust the angle of the lamp body according to the angle of the light that needs to illuminate the object, and fix the lamp body;
Wiring, connect the brown wire left on the side of the lamp to the positive pole of the power supply, and the blue wire to the negative pole of the power supply.
After confirming that the connection is correct, the power supply is turned on to work normally.
In order to ensure the normal operation of the product, please use the voltage within the lamp's label voltage range;
Please follow the correct installation steps to install the product;
When installing or removing the product, please disconnect the power of the lamp to avoid the risk of leakage.
If it is not the cause of the operation, please confirm whether the following reasons are caused. If the method is followed, the problem cannot be solved. Please stop using and contact a qualified electrician or contact the manufacturer directly.
A: Does the luminaire not illuminate after the power is turned on?
Disconnect the power supply. Check if the power cord of the lamp is well wired to the power supply (or mains) and the power supply is good.
B: Good wiring is still not working?
Have a qualified electrician check if the power supply voltage of the luminaire is lower than the rated voltage of the luminaire itself.
Be sure to turn off the power before cleaning the lamp;
Please do not use cosmetic items or corrosive things for cleaning.